# Installation Steps
# During Construction
Pre-Wiring
- Pass all your cat cables and other wires required to power all the lights you will be installing.
Enclosures Installation
- Install the Enclosures by mounting them to walls, or having them recessed into the wall.
# Post construction / Pre-finish
DMX Drivers Installation
- Mount all your DMX Drivers into the Enclosures.
DMX Amplifiers Installation
- Mount a DMX Amplifier in each enclosure that has more than 4 DMX drivers
Gateway Installation
- Mount a Gateway. Depending on how many DMX Drivers you have, you may have to mount more than one Gateway.
Hookups
- Connect all power cables for devices.
- Connect luminaires and LED Tapes to the right DMX drivers
- Connect the DMX drivers to a DMX Isolator Amplifier. No more than 4 drivers in a daisy chain connected to one port.
- Connect the Gateway's DMX port to a DMX Amplifier.
- Connect the Gateway's RJ45 port to an IP network.
# Post-Finish
DMX Driver addressing
- Configure a DMX address for each DMX Driver.
Gateway configuration
- Connect to the Gateway with the Chrome web Browser(preferably in incognito mode) using the Gateway's IP address.
- Enter each lighting load and DMX Drivers at their configured address.
- Create Scenes and Keypads in the Gateway configuration.
-
- Integrate with a 3rd party system for more in sync control with the rest of the building. (See the 3rd Party Integration section for more details)